|
Written by OKA
|
|
Saturday, 05 July 2008 03:06 |
| D-Client Instructions The section below has all the different instructions you need for d-client. Unlocking DB2012 CID50, DB2020 CID52 and DB2020 CID49/51 Phone 1. Download and install the drivers for your phone.The open the d-client tool and select the settings tab then enter your username/password.
2. Connect your phone and press the attach button whilst holding the C button. Then release and server will make connection.
3. Select your model and version from the drop down menu 4. Check the unlock box Then press the go button to being the process. Server will then send files to the phone with should take a few mins. After a few mins a pop up will appear saying
Step 1: Disconnect phone and reconnect its battery! Press OK, then connect the phone while holdings its C-button. Make sure you you remove the phone battery and cable from each other or you will get an error at this point. Then hold the C-button reconnect and follow the steps in screen. You will be asked to do this a few times always follow the steps above. After server has completed unlock software will display EPI USB CLOSED SUCESSFULLY - your phone is now unlocked remove battery then reconnect.
 Flashing and Debranding (Except DB3150)
1. Download and install the drivers for your phone. The open the d-client tool and select the settings tab then enter your username/password.
2. Connect your phone and press the attach button whilst holding the C button. Then release and server will make connection.
3. Select your model and version from the drop down menu 4. Then select flash and customize from the menu box. 
Then Select the go button to begin the process. 
At the end of the process you will see a confirmation message of EPI USB CLOSED SUCESSFULLY. Disconnect the battery and cable and then replace the battery on the phone. |
Flashing and Debranding DB3150 Models
1. Download and install the drivers for your phone. The open the d-client tool and select the settings tab then enter your username/password.
2. Connect your phone and press the attach button whilst holding the C button. Then release and server will make connection.
3. Select your model and version from the drop down menu 4. Then select flash and customize from the menu box.
Select the files you want by using the + symbol make sure there the correct format. Ending A2SW and A2FS. 
Then Select the go button to begin the process. This may take a few mins.
At the end of the process you will see a confirmation message of EPI USB CLOSED SUCESSFULLY. Disconnect the battery and cable and then replace the battery on the phone. You job is now completed. |
|
|
|
|
Last Updated on Saturday, 05 July 2008 03:19 |
Instructions 
